Peugeot 307 reliability
The Peugeot 307 fails its MOT more often than most cars over 10 years old: 51.2% of 39,419 tests failed in 2023, against 39.7% on average.
24 DVSA recalls for the Peugeot 307
Most cover a batch of cars built in a set period, and dealers fix them free. Sweep’s check shows the recalls for a car’s age and whether the DVSA has one outstanding.
Braking assistance may not perform correctly
In very rare circumstances the vacuum pump one way valve may not function correctly which could affect the level of braking assistance.
Fix: Recall the vehicles that are likely to be affected to replace the brake vacuum pump one way valve.
Recalled models: 307 · 24,220 vehicles
Lights may fail without warning.
It has been identified that the position of the exterior lighting control ring may not be detected by the lighting management system and the lights may switch off without warning.
Fix: Recalled vehicles will have the lighting management software updated.
Recalled models: 307 · 2,903 vehicles
Lights may switch off unexpectedly
In rare cases the lighting management system may incorrectly detect the lighting switch ring position which may cause the lights to cut out.
Fix: Recall affected vehicles and download new version of vehicle exterior lighting software
Recalled models: 307 · 48,938 vehicles
Fuse box may cause equipment operational failures
It has been identified that the main engine fuse box is not to the correct specification. This can result in operating faults or the failure of certain equipment.
Fix: Recalled vehicles will have the subject fuse box replaced.
Recalled models: 307 · 7,360 vehicles
Reduced braking performance
It has been identified that on the specified vehicles a fault may develop with the brake vacuum pump. This can result in hardening of the brake pedal with an attendant loss of braking efficiency.
Fix: Recalled vehicles will have the vacuum pump replaced.
Recalled models: 307 · 19,867 vehicles
Potential loss of abs and esp functions
It has been identified that the operation of the ABS/ESP braking unit may be affected by the ingress of water.
Fix: Recall likely to be affected vehicles to reinforce the resistance of the ABS/ESP unit to water.
Recalled models: 307 · 210,973 vehicles
Rear axle fixing bolts may become loose
The quality of the welding at the suspension mounting reinforcement plates may not be to specification.
Fix: Recall the vehicles that are likely to be affected and check the welding. Where necessary take corrective action to ensure that the reinforcement plate welding operation has been correctly completed.
Recalled models: 307 · 221 vehicles
Fuel may leak
Due to a potential fault in the engine management system an internal engine fuel leak via the injectors may occur following switching off. This would result in the engine failing to restart due to excess fuel being present in the inlet manifold or cylinders.
Fix: To address the issue recalled vehicles will receive an engine management download.
Recalled models: 307 · 4,338 vehicles
Airbag may deploy inadvertently
The incorrect fixing of the left hand curtain airbag can lead to incorrect deployment in the case of a left hand side impact or frontal impact with a high degree of angular bias to the left.
Fix: Recall the vehicles that are likely to be affected and re-fix the airbag correctly.
Recalled models: 307 · 1 vehicles
Brakes may fail
It is necessary to check the fitting of the pedal box transfer bar levers on (RHD only). In rare cases where the return bar lever is faulty the braking efficiency could be affected.
Fix: Recalled vehicles will have the transfer bar checked and replaced if found to be faulty.
Recalled models: 307 · 11,522 vehicles
Corrosion of electrical connection which could cause a short circuit
It is necessary to check and reinforce the sealing of the electrical connections for the ABS system. As under certain conditions the repeated entry of salt water into this connection could cause short circuits which may lead to a fire within the engine compartment
Fix: Recalled vehicles will have numerous checks carried out and repairs completed dependent upon what is found.
Recalled models: 307 · 151,100 vehicles
Risk of fire in engine compartment
It is necessary to reinforce the sealing of electrical connections for the steering system electro pump assembly. As under certain conditions the repeated entry of salt water into this connection could cause short circuits which may lead to a fire within the engine compartment.
Fix: Recalled vehicles will have numerous checks carried out and repairs completed dependent upon what is found.
Recalled models: 307 · 107,767 vehicles
Possible seepage on the diesel fuel return pipe
There is a risk of a manufacturing non conformity on the fuel injection diesel return pipe. This may lead to the possibility of fuel seepage.
Fix: As a preventive measure likely to be affected vehicles will have the pipe replaced additionally the pipe will be fitted with protective sleeves.
Recalled models: 307 · 2,573 vehicles
Concern that the lower axle swivel joint was not tightened correctly
There is a risk that the lower swivel joint on the front suspension has not been sufficiently tightened.
Fix: Check the mounting and tightness of the joint if found out of specification replace the joint.
Recalled models: 307 · 14,109 vehicles
Failure of the throttle stop could lead to a reduction in braking assistance
The original engine software may cause erratic operation of the motorised throttle body. This could in rare extreme cases cause the throttle stop to break. This will cause the engine to revert to limp home mode which possible may cause a reduction in braking assistance.
Fix: Install updated software in the engine ECU.
Recalled models: 307 · 8,599 vehicles
The vehicle may not be correctly fitted with a rear seat anchorage point strengthener
It is a possibility that vehicles may not be correctly fitted with a rear seat anchorage point strengthener. If the strengthener is not fitted the vehicle will not comply with the defined retention criteria in the case of an accident.
Fix: Recalled vehicles will be inspected for the presence of the seat anchorage strengthener. In cases where it is not in place the vehicle will be returned to specification.
Recalled models: 307 · 150 vehicles
Weld points on rear side chassis members may have not been made correctly
The possibility exists that the weld points on the chassis rear side members may not have been made correctly. With the result that in the case of an impact the vehicle would not comply with the energy absorption criteria.
Fix: Likely to be affected vehicles will be recalled for checking of the subject welds. If it is found that the welds are not to specification Product Service should be contacted.
Recalled models: 307 · 303 vehicles
Possibility that egr support bracket may break
There is a possibility that the EGR support bracket may break and cause a short circuit which may stop the engine.
Fix: Recall affected vehicles and replace EGR bracket.
Recalled models: 307 · 9,510 vehicles
Possibility of cuts in tyres.
Due to an incident during the vehicle manufacturing process there may be cuts in the side wall or tread of one or both of the tyres on the right hand side of the vehicle.
Fix: Examine the tyres fitted to the vehicle and replace any that are found to be cut.
Recalled models: 307 · 554 vehicles
Possibility that vehicle could be started with gear selector in any position
The automatic gearbox control wiring loom may become pinched. This may make it possible to start the engine whilst the car is in gear.
Fix: Check whether the wiring loom is being pinched. Repair and reposition the loom where found necessary.
Recalled models: 307 · 102 vehicles
Front brake pipe may chafe on anti roll bar
The front left hand anti-roll bar linkage may contact and chafe the brake pipe when turning the wheels to full left lock.
Fix: Inspect and where necessary reposition the left front brake pipe.
Recalled models: 307 · 380 vehicles
Incorrect specification brake fluid
It is possible that the brake fluid is not to the correct specification. this over a period of time could adversely affect the brake performance.
Fix: Replace the hydraulic fluid in the brake and clutch operating circuits.
Recalled models: 307 · 91 vehicles
Front shock absorber concern
The front shock absorber lower yoke might not be to the correct specification. As a consequence the yoke may fracture and cause a deterioration in the vehicles road holding.
Fix: Recall affected vehicles and examine the front shock absorber lower support for cracks. Fit new shock absorbers where necessary.
Recalled models: 307 · 647 vehicles
Ignition switch fire risk
Key operation in the steering lock ignition switch may become stiff or could seize. An ignition switch seized in the start position could result in a starter motor burn out.
Fix: Replace the complete steering lock assembly.
Recalled models: 307 · 28,876 vehicles
Checking a Peugeot 307 before you buy
Look at the parts above at the viewing, and read the car’s own MOT history: advisories for the same parts suggest the problem is already starting. Sweep’s free check shows every MOT, advisory and mileage reading for a registration.